MIL-DTL-15606J
d. When the Acceptance Quality Levels (AQL) of 2.5 can be used for workmanship (see 4.5.4), inspection
level S-1, and AQL 2.5 can be used for dimensional verification tests (see 4.5.4.1 and 4.5.4.2), inspection level S-3.
e. When the Government reserves the right to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
f. Dimensions and shape of brick and burner tile as specified on applicable drawings; special shapes of burner
g.
h.
i.
Dimensions and tolerance of burner tile as specified on the applicable drawings (see 3.4.3 and 4.5.4.3).
j.
k.
When the unit of sample is other than one brick or one tile (see 4.2).
l. When the average of nine samples during the permanent volume change test is permitted to determine
rejection of the lot (see 4.6.3).
m. When the average of ten samples during the modulus of rupture test is permitted to determine rejection of
the lot (see 4.6.4).
n. When the average of nine bricks during the stability test is permitted to determine rejection of the lot
(see 4.6.5).
o. When the average of nine tiles during the permanent linear change test is permitted to determine rejection
of the lot (see 4.6.6).
p.
q.
Level of packing required, including method of waterproofing pallets if required (see 6.8.2).
r.
If palletization is required for Level A (see 6.8.2.1).
s. Additional requirements for Certificates of Compliance (see 6.5 and 6.10), Reference to Navy Data Item
Description DI-MISC-81356 or similar data requirement for content and format.
6.3 Applicable documents.
6.3.1 General. The documents listed in this section are specified in section 6 only of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples.
6.3.2 Government documents.
6.3.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form
a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
FEDERAL SPECIFICATIONS
NN-P-71
-
Pallets, Material Handling, Wood, Stringer Construction, 2-Way and 4-Way (Partial)
FEDERAL STANDARDS
FED-STD-313
-
Material Safety Data, Transportation Data, and Disposal Data for Hazardous
Materials Furnished to Government Activities
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-129
-
Military Marking for Shipment and Storage
MIL-STD-147
-
Palletized Unit Loads
MIL-STD-2073-1
-
Standard Practice for Military Packaging
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business